Not cheap, but you get what you pay for. Designed by me to lighten up Halloween play sessions.

This electrode insulator is made from ABS (think Lego plastic), it's hard-wearing, non-porous and doesn't need painting or any other finish. To produce these electrodes I have had to invest in new equipment, and the post-print processing time to get the smooth, non-porous finish takes me a long time, and this is reflected in the price. If you prefer the best, then this is the version for you. They will be available in very limited quantities, so grab one while you can.

This anal or vaginal insertable loop insulator is printed in my Orange ABS. It comes with 10"/25cm of 6mm conductive rubber tubing that takes a 2mm plug.

It will be dispatched with the 6mm conductive rubber tubing already fitted.

The inner hole size is 1mm larger than the CR tubing, this 6mm tubing is a good friction fit, and you don't need the plastic locking clamp to keep it in place once fitted.

Note: This product is supplied as is, and I am not liable for any problems that arise from its use. It is sold as a novelty item and carries no warranty. Your statutory rights remain. Images shown are renderings.

Material

This product is 3D printed in ABS, a very strong plastic that has excellent mechanical properties. Once printed I post-process the components using a procedure called vapour smoothing. This uses Acetone vapour to actually melt and smooth the surface of the prints turning them from rough prints into smooth shiny prints that are non-porous.

Porosity is one drawback of the 3D printing process as it leaves microscopic holes in the surface of prints that are perfect for bacteria to grow in and hard to clean. Vapour smoothing prints seals these microscopic holes and imperfections, leaving the products smooth and sealed.

This is important as it makes cleaning post-play so much easier.

Sharing

However, I do not recommend these products are shared between partners unless you are fluid bonded for obvious reasons.

Product Care

After play simply wash in warm soapy water, anti-bacterial soap is best. Once body fluids have been washed off allow the electrode to dry thoroughly before you store it away for later use.

A deep clean can be carried out using Isopropyl Alcohol, this will kill bacteria and remove body oils.

Never use silicone-based lubes with conductive rubber-based electrodes as the silicone will bond to the conductive rubber, effectively destroying it and insulating it.