I have designed a 3D printable vaginal or anal Monopole Conductive Rubber Electrode that I am calling my Loveheart Electrode. The design is done and is available for download on my Gdrive, so if you have access to a 3D printer, you can make one yourself.

However, if you do not own a 3D printer, I am offering a service where I will print one out for you and send it to you. Each Love Heart Electrode will be printed in RED PLA. This insulator comes with 10"/25cm of 6mm conductive rubber tubing that takes 2mm plugs.

Show someone you care when you stim them with this passionate little electrode.

It will be dispatched un-painted but with 6mm conductive rubber tubing already fitted. One side of the Conductive Rubber loop has a pin fitted to secure it in place. Your TENS cable plug secures the other end; you can remove this plug to allow two plugs to attach to this electrode from different channels if you are using a Tri-phase set-up to make it the base connector.

Just plug in your 2mm plug and then insert it into your vagina or anus before switching on your control box and experiencing some e-stim pleasure.

I recommend that you paint it first though, to seal the surfaces with a plastic paint such as Krylon Fusion For Plastic.

Note: This product is supplied as is, and I am not liable for any problems that arise from its use. It is sold as a novelty item and carries no warranty. Your statutory rights remain. Images shown are renderings; the printed product will show some layer lines and require light sanding.