Two cock loop set designed by me to make hands free orgasms easier to achieve.

When using conductive rubber cock loops for stimming you generally only stimulate the dorsal nerves running along the top of the penis. The sensations generated are felt at the glans of the penis. Insulating the top part of a lower cock loop if it is around the cock and balls allows you to stim both the Dorsal and Perineal nerves leading to a better sensation.

For more information about stimming these nerves, check out my Electrosex Penis Play Guide For Hands-Free Orgasms.

I have designed a basic 3D printable cock loop insulator and guide for Conductive Rubber Cock Loops. The design is done and it is freely available for download on my site if you have access to a 3D printer so that you can make one yourself.

However, if you do not own a 3D printer then I am offering a service where I will print one out for you and send it to you. Each cock loop insulator will be printed in my trademark YELLOW PLA. This insulator comes with 15"/38cm of 6mm conductive rubber tubing that takes 2mm plugs.

You also get another 6mm conductive rubber cock loop with a lock sized for 6mm CR.

They will be dispatched un-painted but with 6mm conductive rubber tubing already fitted.

The inner hole size in the insulator is 1mm larger than the CR tubing, this 6mm tubing is a good friction fit and you don't need the plastic locking clamp to keep it in place once fitted. Just slip it over your cock and tighten it before plugging your 2mm plug into the CR.

Check Out The Instructions For This Electrode

I recommend that you paint it first though to seal the surfaces with a plastic paint such as Krylon Fusion For Plastic.

Note: This product is supplied as is and I am not liable for any problems that arise from its use. It is sold as a novelty item and carries no warranty. Your statutory rights remain. Images shown are renderings, the printed product will show some layer lines and require light sanding.