I charge a nominal fee for the STL files and instructions for my more complicated designs. This is one of those designs.

I print mine in ABS, but you could use PLA or PETG instead.

NOTE: You are purchasing a zip file containing six STL files and a PDF containing the instructions and suggested print settings for creating this electrode.

You will need one 16.5cm/6.5" length of 6mm Conductive Rubber and one 30cm/11" length of 4mm conductive rubber for the electrode surfaces. You will also need an M3 heat set insert, an M3x18 bolt (preferably nylon) and two 4mm cord locks.

STL Files:

Size_1_Loop.stl – The lower cock loop, 26mm/1".

Size_2_Loop.stl – The lower cock loop, 32mm/1.25".

Size_3_Loop.stl – The lower cock loop, 38mm/1.5".

8mm_Holder.stl – The top component catering for sounds up to 8mm in diameter.

12mm_Holder.stl – The top component catering for sounds up to 12mm in diameter.

Diamond_Holder.stl - The top component to hold an E-Stim Systems Diamond Plug Sound.

Components/Material Required:

1 x 6mm Conductive Rubber, approximately 16cm/6.5" long.

1 x 4mm Conductive Rubber, approximately 30cm/11" long.

1 x M3 heat set insert.

1 x M3x18 Bolt, preferably nylon.

2 x Conductive rubber cord locks.

I provide all of the hardware required to make up one of these electrodes here to save you time and effort in sourcing the parts, as some are only available for bulk buys. Get A Hardware Kit Here.

I am not releasing the copyright to this design or the files purchased; you may not distribute them, and you can only make PERSONAL prints.

If you want one printed in ABS, you can get it here - Sound Clamping Monopole Glans ElectrodeSound Clamping Monopole Glans Electrode.