NEW Design by me to make hands-free orgasms easier to achieve. This one features two loops on the side that can be used to thread a cord or elastic through to hold it firmly against your body.

When using conductive rubber cock loops for stimming, you generally only stimulate the dorsal nerves running along the top of the penis. The sensations generated are felt at the glans of the penis. Insulating the top part of a lower cock loop, if it is around the cock and balls, allows you to stim both the Dorsal and Perineal nerves leading to better sensations.

For more information about stimming these nerves, check out my Electrosex Penis Play Guide For Hands Free Orgasms.

Each cock loop insulator will be printed in my BLACK PLA. This insulator comes with 10"/25cm of 8mm conductive rubber tubing that takes 4mm plugs.

I will also include a small length of 4mm CR that takes 2mm plugs so that it can be used as an adaptor to allow you to use 4mm or 2mm plugs on this one.

Suggestion: Fit the short length of 4mm CR into one end of the loop, and then you can use either a 4mm plug or a 2mm one.

It will be dispatched un-painted but with 8mm conductive rubber tubing already fitted.

The inner hole size is 1mm larger than the CR tubing, this 8mm tubing is a good friction fit, and you don't need the plastic locking clamp to keep it in place once fitted. Just slip it over your cock and tighten it before plugging your 4mm plug into the CR (or use the included 4mm CR to use a 2mm plug).

Check Out The Instructions For This Electrode

I recommend that you paint it first to seal the surfaces with a plastic paint such as Krylon Fusion For Plastic.

Note: This product is supplied as is, and I am not liable for any problems that arise from its use. It is sold as a novelty item and carries no warranty. Your statutory rights remain. Images shown are renderings, the printed product will show some layer lines and require a light sanding.