Designed by me to make two channel penis play much easier.

This double cock loop enables you to quickly achieve two things. Firstly the insulation on the top half of the lower loop isolates the Dorsal nerve. This means if you use this loop with a pad or loop electrode on your glans, you will stimulate both the Dorsal and Perineal nerves at the same time - bonus. For more information about stimming these nerves, check out my Electrosex Penis Play Guide For Hands Free Orgasms.

The front cock loop is designed to be used in conjunction with a pad electrode behind the anus or with an insertable butt plug style electrode to directly stimulate the prostate.

Used in this way with two channels it delivers crisp and intense sensations target at the Dorsal and Perineal nerves as well as the Prostate.

It also keeps things neat and tidy.

The two yellow plugs can be removed to allow a second plug to be fitted to each loop, so either can become the base electrode in a tri-phase configuration.

You can also move the plugs so the protruding conductive rubber either exits the electrode along the length of the penis or tangential to is giving you more options for cable management.

All in all, I am delighted with this design that took me over two months to perfect with numerous prototype models until I was happy to release it. Each of these electrodes will be printed in my trademark YELLOW PLA.

This electrode comes with two 6mm conductive rubber loops that take 2mm plugs, the lower one is 10"/25.4cm long, and the upper one is 8"/20.3cm long. Once you have initially fitted it, you can trim these down to a manageable length.

It will be dispatched un-painted but with 6mm conductive rubber tubing already fitted.

I recommend that you paint it first, though, to seal the surfaces with a plastic paint such as Krylon Fusion For Plastic.

Note: This product is supplied as is, and I am not liable for any problems that arise from its use. It is sold as a novelty item and carries no warranty. Your statutory rights remain. Images shown are renderings, the printed product will show some layer lines and require a light sanding.