[tab name='Product Description']

The resounding success and positive feedback I received about my insulated loops made me decide to design a double monopole cock loop. "Why would I want to use a double loop?" I hear you ask.

Well, insulating a conductive rubber loop has only one drawback: you lose half of the skin surface area by doubling the loop up you get that back for a smoother ride. While still retaining all the benefits of insulating the upper half of the loop. For more information about stimming these nerves, check out my Electrosex Penis Play Guide For Hands-Free Orgasms.

This electrode insulator is made from Di-Chromatic PLA. Each will be different due to the printing process and nature of this filament, but the image gives you a good idea of what to expect. They will be available in very limited quantities, so grab one while you can.

When using conductive rubber cock loops for stimming, you generally only stimulate the dorsal nerves running along the top of the penis. The sensations generated are felt at the glans of the penis. Insulating the top part of a lower cock loop if it is around the cock and balls, allows you to stim both the Dorsal and Perineal nerves leading to better sensations.

These double loops are perfect for use as the common in a tri-phase configuration; just plug one cable from each (different) channel into each end of the loop.

This cock loop insulator is printed in Di-Chromatic PLA. This insulator has a generous length of 20"/50cm of 6mm conductive rubber tubing that can be trimmed down to suit your anatomy. The high-quality British CR takes a 2mm plug.

It will be dispatched with the 6mm conductive rubber tubing already fitted.

The inner hole size is 1mm larger than the CR tubing, this 6mm tubing is a good friction fit and you don't need the plastic locking clamp to keep it in place once fitted but I will ship it with one fitted anyway. Just slip it over your cock and tighten it before plugging your 2mm plug into the CR.

Check Out The Instructions For An insulated Electrode

Note: This product is supplied as is, and I am not liable for any problems that arise from its use. It is sold as a novelty item and carries no warranty. Your statutory rights remain. Images shown are renderings.

Material

This product is 3D printed in ABS, a very strong plastic that has excellent mechanical properties. Once printed I post-process the components using a procedure called vapour smoothing. This uses Acetone vapour to actually melt and smooth the surface of the prints turning it from rough prints into smooth shiny prints that are non-porous.

Porosity is one drawback of the 3D printing process as it leaves microscopic holes in the surface of prints that are perfect for bacteria to grow in and hard to clean. Vapour smoothing prints seals these microscopic holes and imperfections, leaving the products smooth and sealed.

This is important as it makes cleaning post-play so much easier.

Sharing

However, I do not recommend that these products are shared between partners unless you are fluid bonded for obvious reasons.

Product Care

After play simply wash in warm soapy water, anti-bacterial soap is best. Once body fluids have been washed off allow the electrode to dry thoroughly before you store it away for later use.

A deep clean can be carried out using Isopropyl Alcohol, this will kill bacteria and remove body oils.

Never use silicone-based lubes with conductive rubber-based electrodes as the silicone will bond to the conductive rubber, effectively destroying it and insulating it.