Designed by me to make hands-free orgasms easier to achieve.

When using conductive rubber cock loops for stemming, you generally only stimulate the dorsal nerves running along the top of the penis. The sensations generated are felt at the glans of the penis. Insulating the top part of a lower cock loop if it is around the cock and balls, allows you to stim both the Dorsal and Perineal nerves leading to better sensations.

For more information about stimming these nerves, check out my Electrosex Penis Play Guide For Hands Free Orgasms.

I have designed a basic 3D printable insulator and guide for Conductive Rubber Cock Loops. The design is done, and it is freely available for download on my site, if you have access to a 3D printer, you can make one yourself.

However, if you do not own a 3D printer, then I am offering a service where I will print one out for you and send it to you. Each cock loop insulator will be printed to order in whatever colour of PLA I have loaded into my machine, so colours will vary.

It will be dispatched unpainted and unfinished, so you may need to give it a light sanding to remove any pieces of the support structure that is printed in place by the 3D printer. This takes no time at all, and then it is ready for use. Simply thread your conductive rubber through the holes.

The inner hole size is 7mm, for 6mm outside diameter conductive rubber tubing as sold by manufacturers like E-Stim Systems or Electrastim. Conductive rubber is not included.

Check Out The Instructions For This Electrode

Note: This product is supplied as is and I am not liable for any problems that arise from its use. It is sold as a novelty item and carries no warranty. Your statutory rights remain. Images shown are renderings, the printed product will show some layer lines and require a light sanding.